3 thoughts on “uIEC/SD final wiring”

  1. Chuck Rysted

    Great job. I was hoping to mimic it if possible. Can you tell all of us what are your soldering point on your wiring?

    Reply ↓
    1. Obliterator918 Post author

      When I soldered the stuff to the bus on the board I ended up “brute forcing it” by using a multi-meter to test which traces connected to which pin on the connector in the back. I used a schematic to know which pin did what, so I would know where to connect it to the sd iec, but I did not make any notes.

      Reply ↓
  2. Kent Cortsen

    Hi there.
    How can I prevent the uIEC/SD from being on IEC bus when powering my C64 up. My uIEC is mounted internally.

    I have read that a switch on ATN wire can do this. But is it just a on/off on that wire og between ATN and GND or something?

    Hope You can help me with this. And You are welcome to reply toy email: wingnutz72@gmail.com.

    Regards Kent Cortsen, Denmark

    Reply ↓

Leave a Reply

Your email address will not be published. Required fields are marked *